BVPCY - FAST DRYING POLYURETHANE GLOSS

  • MSDS: BVPCY
  • Manufacturer: MINWAX CO INC
  • Product Name: FAST DRYING POLYURETHANE GLOSS
  • National Stock Number: 8010-00N052826
Product Identification

Product ID:FAST DRYING POLYURETHANE GLOSS
MSDS Date:10/20/1993
FSC:8010
NIIN:00N052826
MSDS Number: BVPCY

Responsible Party
MINWAX CO INC
15 MERCEDES DR
MONTVALE, NJ 07645
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 201-573-5700

Cage: HO333

Contractor
MINWAX COMPANY
UPPER SADDLE RIVER, NJ 07458 US

Telephone: 800-523-9299/216-566-2917

Cage: 0K1A4

Ingredients

STODDARD SOLVENT; (MINERAL SPIRITS)

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: 53-61%

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGEST:CAN CAUSE GASTROINTESTINAL
IRRITATION, NAUSEA, VOMITING & DIARRHEA. SKIN:CAN CAUSE DEFATTING &
DRYING OF SKIN; WHICH MAY RESULT IN SKIN IRRITATION & DERMATITIS.
EYES:CAN CAUSE SEVERE IRRITATION , REDNESS, TEARING & BLURRED
VISION. INHAL:CAN CAUSE NASAL & RESPIRATORY IRRITATION, DIZZINESS,
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:FATIGUE, NAUSEA, HEADACHE, NERVOUS
IRRITABILITY, UNCONSCIOUSNESS & ASPHYXIATION.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:EYES:REMOVE CONT LENS IF PRESENT; FLUSH EYES W/PLENTY OF
WATER FOR AT LST 15 MINS & GET MED ATTN. SKIN:WASH THORO W/SOAP &
PLENTY OF WATER. IF IRRIT PERSISTS, GET MED ATTN. INGEST:DO NOT
INDUCE VOMIT. CALL MD IMMED! KEEP PATIENT WARM & QUIET.
INHAL:REMOVE TO FRESH AIR. MAINTAIN RESP AS NEC & CALL MD. NOTE TO
MD:IF SWALLOWED: ASPIR OF MATL INTO LUNGS DUE TO VOMIT CAN CAUSE
PNEUM WHICH CAN BE FATAL.

Fire Fighting

Flash Point:101F,38C
Lower Limits:0.9%
Upper Limits:6%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, ALCOHOL FOAM & WATER
FOG. WATER IS NOT NORMALLY EFFECTIVE EXTINGUISHING AGENT.
Fire Fighting Procedures:USE NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP .
WHEN BURNIN, THIS PROD GIVES OFF TOX BY PRODS SUCH AS CARBON
MONOXIDE. BRTHG THESE SMOKE & GASES (SUPDAT)
Unusual Fire/Explosion Hazard:NONE.

Accidental Release

Spill Release Procedures:PROVIDE ADEQ VENT. REMOVE IGNIT SOURCES FROM
SPILL AREA. UTILIZE SAND, RAGS, PAPER, VERMICULITE, FLOOR ABSORBENT
MATL & PLACED IN LEAK-PROOF DRUMS FOR DISP. USE PROT EQUIP. KEEP
OUT OF SURF WATERS & A NY WATER COURSES/SEWERS ENTERING/LEADING
(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:DO NOT USE/STOR NEAR HEAT, SPKS, OPEN
FLAMES/OTHER SOURCES OF IGNIT. CLOSE CNTNR AFTER EACH USE. STORE
ONLY IN ORIGINAL CNTNR. DO NOT TAKE INTERNALLY.
Other Precautions:AVOID SPONT COMBUST OF CONTAM RAGS & OTHER EASILY
IGNITABLE ORG ACCUMS BY IMMED IMMERSION IN WATER. EMPTY CNTNRS MAY
RETAIN RESIDUES OF PROD; DO NOT CUT, PUNCTURE/WELD ON/NEAR CNTNR.
AVOID INHAL & USE ONLY W/ADEQ VENT. IF EMPLOYEE (SUPDAT)

Exposure Controls

Respiratory Protection:IF ADEQUATE VENTILATION CANNOT BE MAINTAINED,
USE NIOSH/MSHA APPROVED RESPIRATORY PROTECTION (TC 23C OR
EQUIVALENT).
Ventilation:PROVIDE CONSTANT FLOW OF FRESH AIR TO MEET TLV
REQUIREMENTS. OPEN WINDOWS & DOORS TO PERMIT FRESH AIR ENTRY (SUPP
DATA)
Protective Gloves:RUBBER, NEOPRENE OR VITRON GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS(SUPDAT)
Other Protective Equipment:EMERG EYE WASH AND DELUGE SHOWER WHICH MEETS
ANSI DESIGN CRITERIA .
Work Hygienic Practices:WASH W/SOAP & WATER BEFORE EATING, DRINKING,
SMOKING OR USING TOILET FACILITIES. REMOVE CONTAM CLTHG IMMED &
(SUPP DATA)
Supplemental Safety and Health
SPEC GRAV:0.854-0.869(H*2O=1). FIRE FIGHT PROC:SHOULD BE AVOIDED. SPILL
PROC:TO SURF WATERS. OTHER PREC:EXPERS EYE WATERING, HDCHS/DIZZ,
INCR FRESH AIR & LEAVE AREA. KEEP OUT OF REACH OF CHILDREN. VEN
T:DURING APPLICATION. EYE PROT:& FULL LGTH FCSHLD . HYGIENE
PRACT:LAUNDER BEFORE REUSE.

Chemical Properties

Boiling Pt:B.P. Text:313F,156C
Vapor Pres:2
Vapor Density:4.8
Spec Gravity:SUPP DATA
Evaporation Rate & Reference:0.09 (BUTYL ACETATE=1)
Solubility in Water:NIL
Appearance and Odor:CLEAR AMBER LIQUID; MILD HYDROCARBON ODOR.
Percent Volatiles by Volume:55-63

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION PRODUCES CARBON
MONOXIDE, CARBON DIOXIDE & UNIDENTIFIED ORGANIC COMPOUNDS.

Disposal

Waste Disposal Methods:DISPOSE I/A/W LOCAL, STATE & FEDERAL
REGULATIONS. INCINERATION IS PREFERRED.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.